Knowledgebase
Geneeworld Support Desk > Geneeworld Support Desk > Knowledgebase

Search help:


How do i configure the Student & Teacher Handsets

Solution

1. Connect the Receiver to an available USB port. The drivers will automatically install and a message will appear in the bottom left of the ClassComm software interface stating “xyz receiver connected” where xyz represents the type of hardware purchased.

2. Once the receiver connected message appears, open the Communication tab of ClassComm. Now test handset communication to the receiver by pressing some keys on the handset and then pressing “send”. The corresponding cell ID’s will light up in the grid.

3. The following image shows the communication grid. In the left panel it shows the number of active handsets and responses received. Note that cells 1 – 4 are lit up to indicate that those are the active handsets. Also note that cell 255 is lit up. This is the Teacher Handset which is a different colour to student handsets and is set to ID 255.

 

Please see the attached image for reference.

Attachments:
ClassComm-Handset-Communication.png ClassComm-Handset-Communication.png

 
Was this article helpful? yes / no
Related articles The handsets are not talking to the receiver. What do I do? (Pebble Pad Only)
The handsets are not talking to the receiver. What do I do? (Genee & IQ-PAD Only)
How do I map handsets to different receivers? (Pebble Pad Only)
What is meant by Mapping Handsets
Class Settings in ClassComm
Article details
Article ID: 63
Category: ClassComm Software
Date added: 26-Apr-2016 1:16pm
Views: 47
Rating (Votes): Article rated 4.2/5.0 (5)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid