Knowledgebase
Geneeworld Support Desk > Geneeworld Support Desk > Knowledgebase

Search help:


Genee Powerboard & Pro Digital+ set up

Solution

The following connections will need to be made to fully utilize your new interactive whiteboard.

Connect the 15 pin VGA cable between your laptop and the projector’s wallplate.

Labelled computer VGA or RGB.

Connect the 3.5mm stereo audio plug into the computer’s headphone socket, and the two

phono plugs at the other end of the cable into the audio inputs on the wall plate.

Finally, there will be a USB cable coming from the whiteboard, usually emerging by the wall plate

for connection into the computer.

Your board comes with a software and driver CD. Ensure that you have administrator rights on

your computer so that you can load this software.

Insert the disc into your computer’s drive.

If the disc does not run automatically you will need to click on “My computer”, then ”CD/DVD

drive” then “open” then the Run/set up exe file.

Follow the on screen instructions. You may be asked to restart your computer before these

additions take effect.

Once you have done this your new board is ready to use.

The board will need to be calibrated before it is used. (this should not need doing again if there is

no change in projector or board position and will always be used with the same computer.)

Calibration can be done by double clicking the new icon that will have appeared in the windows

toolbar at the very bottom right hand side of your desktop. This will then give you another menu

of five or so options. Click on calibrate.

You will then get a series of crosses projected onto the whiteboard. Hold the whiteboard pen

onto each of the crosses as they appear. Once the sequence has finished you will need to save it

when asked, by clicking on the save option that will be displayed after the sequence.

Calibration can be done as often as required.

 
Was this article helpful? yes / no
Related articles Will it have all of the cables I need to plug it in immediately?
Touch Interactivity Not Working
I can’t calibrate the board properly
Do I need to load the Genee Toolbar software and drivers if I’m never going to want to capture any still or moving images?
The output to my projector goes via a splitter box. Can I still connect the visualiser in?
Article details
Article ID: 61
Category: Interactive Whiteboards
Date added: 26-Apr-2016 12:54pm
Views: 617
Rating (Votes): Article rated 3.7/5.0 (6)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid